- Knowledge Base
- Products
- Drives
- SINAMICS G120
- I am unable to see any drives using Accessible nodes. What problems could there be?
Several issues could be the cause of this. A few typical causes are listed below:
- Communication cable is unplugged/damaged.
- Drive is in a boot up state.
- Flash card is unplugged.
- Installed hardware revisions are not correct.
PG/PC
- Programming device has not been assigned in NetPro.
- Correct communication path, Device/S7ONLINE, has not been selected.
- Incorrect communication protocol has been set.
Profinet
- IP address on the programming device is not set to the range of the drive or is the same address.
- Using an eWON connection.
Profibus
- Baud rate is set incorrectly.
- Node address on the programming device is the same as the drive.
- “PG/PC is the only master on the bus” is/is not set. This is specific for direct connection to a drive or via a routing method.
OUR PARTNERS
Authorised Distribution Partner For
